Library filed under Zoning/Planning from Canada

CanWEA Releases New Siting Guidelines and Model Zoning Bylaw for Small Wind Turbines

OTTAWA, ON, May 31 /CNW Telbec/ - The Canadian Wind Energy Association (CanWEA) today released a report designed to facilitate the installation of small wind turbines across Canada. The report provides guidance for both consumers and municipalities on "Best Practices" that will ensure the proper installation of turbines under 300 kilowatts (kW) rated capacity in Canadian homes, farms and businesses.
1 Jun 2006

Mono revises draft bylaw on wind power

Changes suggested during a public meeting in January on Mono's wind generation policy have been made to a draft bylaw and a decision on whether to pass it will likely be made after the town's revised Official Plan is adopted. Most of the changes were to make the wording of the bylaw clearer.
31 Mar 2006

Working Paper: Utility-scale Wind Power: Impacts of Increased Penetration

Dti3_20robin_20oakley_20atl_1__thumb This working paper is made available by the Resource and Environmental economics and Policy Analysis (REPA) Research Group at the University of Victoria. REPA working papers have not been peer reviewed and contain preliminary research findings. They shall not be cited without the expressed written consent of the author(s). Editor's Note: The authors’ conclusion regarding ‘effective capacity’, i.e. the measure of a generator’s contribution to system reliability that is tied to meeting peak loads, is that it “is difficult to generalize, as it is a highly site-specific quantity determined by the correlation between wind resource and load” and that ‘values range from 26 % to 0% of rated capacity.” This conclusion is based, in part, on a 2003 study by the California Energy Commission that estimated that three wind farm aggregates- Altamont, San Gorgonio and Tehachpi, which collectively represent 75% of California’s deployed wind capacity- had relative capacity credits of 26.0%, 23.9% and 22.0% respectively. It is noteworthy that during California’s Summer ’06 energy crunch, as has been widely publicized in the press, wind power produced at 254.6 MW (10.2% of wind’s rated capacity of 2,500MW) at the time of peak demand (on July 24th) and over the preceding seven days (July 17-23) produced at 89.4 to 113.0 MW, averaging only 99.1 MW at the time of peak demand or just 4% of rated capacity.
1 Jun 2005

https://www.windaction.org/posts?location=Canada&p=26&topic=Zoning%2FPlanning
back to top