Large wind turbines require a large amount of energy to operate. Other electricity plants generally use their own electricity, and the difference between the amount they generate and the amount delivered to the grid is readily determined. Wind plants, however, use electricity from the grid, which does not appear to be accounted for in their output figures.

Energy losses in the U.S. T&D system were 7.2% in 1995, accounting for 2.5 quads of primary energy and 36.5 MtC. Losses are divided such that about 60% are from lines and 40% are from transformers (most of which are for distribution).

Responsive load is the most underutilized reliability resource available to the power system today. It is currently not used at all to provide spinning reserve. Historically there were good reasons for this, but recent technological advances in communications and controls have provided new capabilities and eliminated many of the old obstacles. North American Electric Reliability Council (NERC), Federal Energy Regulatory Commission (FERC), Northeast Power Coordinating Council (NPCC), New York State Reliability Council (NYSRC), and New York Independent System Operator (NYISO) rules are beginning to recognize these changes and are starting to encourage responsive load provision of reliability services.
The Carrier ComfortChoice responsive thermostats provide an example of these technological advances. This is a technology aimed at reducing summer peak demand through central control of residential and small commercial air-conditioning loads..........

Editor's Note:This paper provides insight into how grids operate.

Although the nation's wind potential is very large, only part of it can be exploited economically. The economic viability of wind power will vary from utility to utility. Important factors not addressed in this study that influence land availability and wind electric potential include production/demand match (seasonal and daily), transmission and access constraints, public acceptance, and other technological and institutional constraints.

Editor's Note: Though dated, this is a worthwhile read if read carefully.

Eric Rosenbloom's primer on the units one tends to encounter in researching energy issues.

Clipper's wind turbine products and specifications are available by clicking on the web link.

General Electric's wind turbine products and related specifications are available by clicking on the web link.

Wind turbines convert the kinetic energy in moving air into rotational energy, which in turn is converted to electricity. Since wind speeds vary from month to month and second to second, the amount of electricity wind can make varies constantly. Sometimes a wind turbine will make no power at all. This variability does affect the value of the wind power……

Editor’s Note: This ‘fact sheet’ is, on the whole, a comparatively fair report. The definitions provided for capacity factor, efficiency, reliability, dispatchability, and availability are useful. Its discussion of back-up generation, marginal emissions and Germany & Denmark, however, is disingenuous as is, to a lesser degree, its discussion of capacity factor and availability. IWA's comments (updated October '06) on these issues follow selected extracts from the 'fact sheet' below.